[tmar]

Started to upgrade the audio in my new F30 320d M Sport

Car has base audio (stereo) and iDrive (No Nav), using setup I had in my E90.

Didn't mean to start today just went out this morning to check to see if the harness that I got from Technic for my E90 would work in the F30 and it does (Photos attached showing harness)

Going to install the following kit:-

Alpine PXE-H650 Audio Processor
JL XD700/5 700W 5 channel amp
Focal 100KRS K2 - Not sure if I can use these yet ( will need to see if there is speaker mounts available)

Threads which helped:-

B33M3R's - Full Audio install ( used this as a base guide for my e90 )
http://www.e90post.com/forums/showth...t=Focal+100KRS

Jason's - F30 iDrive removal
http://www.f30post.com/forums/showthread.php?t=716189

So far I have got all the harness's installed from the front to the rear, and have striped the boot but have slowed down a bit has I have had to make mounts out of mdf to hold the AMP and audio processor.

Have decided to mount the amp and audio in the space were the cd changer would go (pics to come), tried to mount the processor in the same I had it in the e90 (shown in the attached pics) but there is not the same room in the F30.

off on monday so hopefully I'll get some more done.

[B33M3R]

Subscribed

[tmar]

Got more done today, AMP and Processor wired up, remote on working ok from harness.

Got some car carpet which doesn't match to bad, and covered the mounts for the amp and processor. Have Got all the car trim back to together again wasn't easy but managed to do it, would of been easy if I could of removed the back part of the rear seats but the catch is different and wasn't able find the release. This would be a good DIY if someone could find out how to do it.

Still got more to do but back to work tomorrow.

[tmar]

Fitted Techinic's jumpers to the connector for the underseat subs and Ran new wiring to the sub from the amp, Will amp the oem speakers till I yet ones to replace them.

Powered on the audio processor and ran through the setup, measure 9 positions for the Audyssey auto calibration, could have done more but have to redo it anyway when I upgrade the speakers.

So far the improvement is noticeable it sounds much better than oem equalised but still lacks the quality which will come from components up front and upgrade rear speakers, Hopefully will get the trim parts ordered soon and make some mounts for the door speakers.

[EB_F30]

Very...Very nice install.

[Algis]

Subscribed

[sosna]

Looks good, planning to do the same.. can you link to where you got the harness from? Tried searching but could not find the same one you have

[tmar]

Originally Posted by sosna

Looks good, planning to do the same.. can you link to where you got the harness from? Tried searching but could not find the same one you have

Got mine from Technic on the forum just PM him.

[Algis]

So did the Focals fit into the doors? Moreover, I've heard that the inner space of the door is opened to water therefore is there additional protection needed to prevent from weather conditions?
Moreover, does such audio upgrade void the warranty?

Could you as well provide an overall update on the progress and your review of the new sound system in place vs base

[sgbk]

wow, great . How much is this system upgrade ? and wired ?

[kasdizzz]

i am also planning to upgrade my base system nice to know it is possible

[vithy]

Did you have a wire the extra speaker cables to the back speakers (Not the back door) and tweeter?