FORUMS
- 5
| 01-02-2013, 01:03 PM | #45 |
|
Second Lieutenant
![]() |
Took my 328 into service last week for squealing brakes and faulty low wiper fluid warning. Service diagnosed the windshield washer issue as a faulty sensor which fails at lower temperatures. New part is on order. Will post updates when repair is complete.
|
![]() |
|
| 01-03-2013, 09:10 AM | #48 |
|
Enlisted Member
![]() |
Picked up my car yesterday.....last night I got in it and it was about 20 degrees F out and I got the false warning. Seems to be pretty common.
I've got to run back to the dealer anyway to pick up something I left in the car I traded. I guess I'll mention it to my CA and let him know about it. At this point, I don't really want to cough up the car I just picked up, so I may not address it for a month or two. It's not like it's a HUUUGE problem, but it's not like I enjoy the false alarm either.
__________________
2013 328i XDrive // Sportline // Mineral Gray // Sport Auto // Tech // Premium // Cold // Lighting
|
|
|
|
| 01-09-2013, 04:54 PM | #50 |
|
Registered
|
Hi I'm new to this forum and have been reading this thread with interest.
I have experienced the same problems with the low level warning and headlight washers that don't spray. I told a friend about the problem and mentioned that it was probably a conductive sensor that was used for the measuring. He then suggested to increase the conductivity of the washer fluid by adding a small amount of salt... I tried with 1/10 of a teaspoon in half a cup of water - stirred it well until it was completely dissolved and then added it to the almost full washer fluid reservoir. After 5 km of driving the headlight washers started working again and when I turned of the ignition and turned it back on the warning light had disappeared and it has stayed like that since ![]() I know this is not a solution to the real problem being a conductive sensor with incorrect sensibility but I hope you can use this information until BMW comes up with a permanent fix. |
|
|
|
| 01-09-2013, 05:20 PM | #51 |
|
F31 320d msport w/HUD
Drives: 320d F31 m, 520d E61 m Join Date: Mar 2012
Location: Sweden, Linköping
Posts: 295
iTrader: (0)
|
I've thought of the salt solution myself and only found the corrosive side of salt to be a potential problem. Any views on that? Say like a corroded and even more useless capacitive sensor?
|
![]() |
|
| 01-11-2013, 02:30 AM | #54 |
|
Enlisted Member
![]() |
|
|
|
|
| 01-16-2013, 11:33 AM | #55 |
|
Private
![]() |
Car was at the dealer and they checked out this problem. The work order details are as follows:
- Checked circuit, and level sensor, found OK - Found PUMA measure 51384106-02, emptied cleaning agent from factory, refilled with BMW washer fluid 83 12 2 293 318 - Client to monitor So it appears that this is in fact a known problem and apparently above is the recommended fix. I will monitor it as things are supposed to cool off again over the next few weeks here in Ottawa (it has been a balmy 5 to -5 Celsius over the last two weeks). Hopefully it's as simple as switching the cleaning agent from the factory. |
![]() |
|
| 01-16-2013, 01:09 PM | #57 | |
|
Private
![]() |
Quote:
As for PuMA this is the best definition/explanation I could find: "Product and Measures Management Aftersales". It is actually "Produkt- und Maßnahmenmanagement Aftersales" PuMA is BMW's online technical hotline for dealers. The dealer fills out a form for submittal to BMW's technical gurus and then they send back a response outlining what they (BMW) want you (the dealer) to do to fix the car. Sometimes it's "replace such-and-such" and sometimes they ask for more diagnostic info. |
|
![]() |
|
| 01-20-2013, 01:07 PM | #59 |
|
Second Lieutenant
![]() |
Just picked up my car from dealer yesterday. They wound up swapping the entire washer fluid tank, which apparently was more practically accomplished than replacing just the sensor inside the tank. So far, warning light is gone, but I'll wait until we have another cold snap to pronounce it completely fixed.
It is interesting to see that other SA are recommending simply changing out the washer fluid rather than swapping any parts. Keep us posted on whether that solves the issue. |
![]() |
|
| 01-20-2013, 08:17 PM | #60 | |
|
Private
![]() |
Quote:
|
|
![]() |
|
| 01-24-2013, 01:41 PM | #62 |
|
New Member
|
I got the low fluid warning as well...had it over the last few days, although it was not caused by a cold snap, it was 60 degrees...I used the windshield wiper fluid MAYBE 3 times, so i know i did not run out, but i am hoping maybe the dealer did not fill it up all the way and only had a little left when i used it all up...
I dropped off the car at the dealership today due to the wind noise that some F30s are experiencing and I mentioned the low fluid warning as well, so we will see what the issue ends up being for that.... ![]() |
|
|
|
![]() |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|