View Single Post
      06-06-2012, 12:43 PM   #1
1.fresh.f30.335
Second Lieutenant
 
Drives: 2014 535xdrive M-Sport
Join Date: Apr 2012
Location: NH-CT

Posts: 286
iTrader: (0)

F30 328i 335i Front Kidney Grill / Grille removal and replacement DIY

BIMMERPOST
     Featured on BIMMERPOST.com
Hey guys,

This is a quick guide to removing and replacing your kidney grills.

Estimated Time: 15-20 minutes

Tools Necessary:
T20 Torx
T30 Torx
small flat head or pick tool

Steps:

1. Locate the rubber hood seal at the front of the engine bay.

Name:  f30grille1.jpg
Views: 40930
Size:  287.2 KB

Name:  f30grille2.jpg
Views: 39292
Size:  228.9 KB


2. Remove the seal, starting at a side will make it easier.

Name:  f30grille3.jpg
Views: 39280
Size:  221.9 KB


3. There are going to be 8 screws (6) T30 torx and (2) T20 torx which need to be removed. A T20 torx screw is located over each headlight

Name:  f30grille4.jpg
Views: 39445
Size:  231.9 KB

Name:  f30grille5.jpg
Views: 39232
Size:  248.6 KB

Name:  f30grille6.jpg
Views: 38589
Size:  185.9 KB


4. Now that all 8 screws are removed, the bumper cover should slide forward. Be careful and make sure to pull straight forward rather than up as there are 4 metal clips which hold the bumper in place which would break.

Name:  f30grille7.jpg
Views: 38123
Size:  193.3 KB

Name:  f30grille8.jpg
Views: 38382
Size:  264.1 KB


5. The bumper cover is flexible to a reasonable extent, allowing for a hand or tool too fit behind the grills. Moving away from the center of the bumper allows for more flex, anyone with big hands would probably find it easiest to start on the outside and work inward.

Name:  f30grille9.jpg
Views: 37951
Size:  167.1 KB

Name:  f30grille10.jpg
Views: 38158
Size:  222.8 KB


6. Now using the flat head or pick tool press the release tabs on the grill while gently pulling on the grill from the outside, there are 3 clips on both the top and bottom of the grill as well as 1 clip on each side.

Name:  f30grille11.jpg
Views: 37882
Size:  253.4 KB

Name:  f30grille12.jpg
Views: 37764
Size:  232.7 KB

Name:  f30grille13.jpg
Views: 37716
Size:  153.2 KB

Name:  f30grille14.jpg
Views: 37521
Size:  177.5 KB

Note: the bottom clips are going to require using your hand rather than the screw-driver because they face the ground.

Name:  f30grille15.jpg
Views: 37753
Size:  197.3 KB


7. Once the first grill is free of the bumper you can easily access the other grill... Don't be impatient and pop a new grill in before having both sides removed, it makes more work for yourself.

Name:  f30grille16.jpg
Views: 37469
Size:  199.0 KB

Name:  f30grille17.jpg
Views: 37886
Size:  308.8 KB


8. Now just gently push the new grills into place, run your hand around the gloss black trim piece to ensure all the clips are secured

*use a microfiber cloth if you don't want fingerprints*

Name:  f30grille18.jpg
Views: 37143
Size:  226.1 KB


9. After the new grills are in place, line the metal clips up with the bumper cover, and then slide it back into place.

Name:  f30grille19.jpg
Views: 37078
Size:  215.6 KB

Name:  f30grille20.jpg
Views: 36991
Size:  175.9 KB

Name:  f30grille21.jpg
Views: 37009
Size:  255.3 KB



10. Once in place replace all 8 screws and prior to tightening them ensure that the bumper cover is even, I did this by comparing two of the outermost points.

Name:  f30grille22.jpg
Views: 36830
Size:  209.5 KB

Name:  f30grille23.jpg
Views: 36738
Size:  246.5 KB


I also repeated this procedure on the rubber seal using the outermost T30 screws as reference points, its not necessary but always helps to keep the car looking it's best.

Name:  f30grille24.jpg
Views: 36533
Size:  185.6 KB

Name:  f30grille25.jpg
Views: 36977
Size:  208.6 KB


I hope this helps answer any questions and Good-luck!
__________________
'12 335i Sport Apline White w/black... Totaled

'14 535i xdrive M-Sport Carbon Black w/Mocha Nappa
1.fresh.f30.335 is offline   United_States
0
Reply With Quote